Creative Discussions > Other Roleplay
[Closed] Random Zombie RP| Time: Day
The-Blades-slave:
Tanu smiled then strolled past Al. He quickly climbed down into the shop and sat down on the floor.
Man, busy day.
nightshade06:
Looking at the bars I see quite a few of them there.
"Jackpot this should work just fine on the glider."
Picking as many as I could up putting them on my shoulder I start walking back to Al's.
"Man I hope no zombies come at me.....If I have to drop these they are going to make a loud noise."
Luckily I reach outside of Al's shop and set them down on the ground.
"Hey Al I found some bars that might work might need a little help getting them up there though....I doubt I could climb and hold these at the same time..."
Handing them up to the roof waiting for them to be taken.
(you can control my character a little bit because I have to go to work...Like have him go into the shop to listen in on whats next.)
Tickles:
Al looked down, and could see the bars. He had nothing to bring them up.
Hang on one sec.
He went inside and downstairs and unlocked the front door. It was a little heavier due to the reinforcement, but he got it open. Tiren got inside with the bars, and Al closed and locked the door again, ensuring that all the pieces were back in place.
Mr. Fox:
Everything goes by in a blur as people run in and out collecting the materials that Al sent them to find. My head feels like it's about to explode, like a damn balloon with too much air in it. I check my leg, no immediate signs of infection, but it doesn't look like it's healing up too well; maybe I just need some more sleep. Nah, I just need to do something to take my mind off of it. "So, is there anything I can do to assist this process?"
Tickles:
Yes, grab some tools and follow the blueprints. I'll start on the right wing, you start on the left.
Tiren and Tanu, we're going to need that radio, so if you brought it with, then it saves you a trip.
Al grabbed some of the bars and began to measure them, and took out a saw to cut. Without power, they can't really use a circular saw, so the hard way was the only way.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version